Lexus NX: Installation
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Automatic Light Control Sensor / Installation
INSTALLATION
PROCEDURE
1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
(a) Attach the 2 claws to install the automatic light control sensor.
2. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY
Click here .gif)
3. INSPECT AUTOMATIC LIGHT CONTROL SYSTEM
for Single Beam Headlight:
Click here
for Triple Beam Headlight:
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CLEARANCE LIGHT ASSEMBLY LH *2 FRONT BUMPER ASSEMBLY *3 FRONT TURN SIGNAL LIGHT BULB - -
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2
SEE MORE:
Fuel Run Out (P3193)
DESCRIPTION The ECM receives the fuel empty low level (below approximately 8.4 L) signal from the combination meter assembly (meter ECU) to detect if the vehicle is running out of fuel. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory P3193 Fuel Run Out All
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE REAR SEAT CUSHION LOCK HOOK NOTICE:
Perform the following only when replacing the rear seat cushion lock hook.
Do not reuse the rear seat cushion lock hook af
© 2016-2026 Copyright www.lexunx.com
