Lexus NX: Combination Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COMBINATION SWITCH ASSEMBLY *2 CONSOLE ARMREST ASSEMBLY *3 INSTRUMENT SIDE PANEL LH *4 LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL *5 NO. 1 INSTRUMEN
Removal
REMOVAL PROCEDURE 1. REMOVE CONSOLE ARMREST ASSEMBLY Click here 2. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Click here 3. REMOVE INSTRUMENT SIDE PANEL LH Click here 4. REMOVE NO. 1 INSTRUM
Installation
INSTALLATION PROCEDURE 1. INSTALL COMBINATION SWITCH ASSEMBLY (for Upper Side) (a) Attach the 4 claws to install the combination switch assembly. 2. INSTALL NO. 2 COMBINATION SWITCH ASS
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (a) Remove the nut and disconnect the transmission control cable assembly from the control shaft lever. (b) Remove the clip from the transmission control cabl
Low Output Signal of Front Speed Sensor RH (C1271,C1272,C1464,C1465)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1271 and C1272 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1
© 2016-2026 Copyright www.lexunx.com
