Lexus NX: Communication Error from MGR to MG2 (P310A-711)

DESCRIPTION

The MG ECU monitors its internal operation for malfunctions.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Warning Indicate

P310A-711

Communication Error from MGR to MG2

Communication error (from the rear motor (MGR) to the motor (MG2))

(1 trip detection logic)

Inverter with converter assembly

Comes on

Master Warning Light:

Comes on

PROCEDURE

1.

REPLACE INVERTER WITH CONVERTER ASSEMBLY

Click here

NEXT

COMPLETED

READ NEXT:

 HV Main Relay (P3110-223)

DESCRIPTION The hybrid vehicle control ECU monitors the IGCT relay and detects the following malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate

 Transmission system (P3147-239,P3147-241)

DESCRIPTION The hybrid vehicle transaxle assembly consists of the planetary gear unit, generator (MG1) and motor (MG2). The planetary gear unit uses a planetary gear to split the engine output into me

 Inverter Coolant Pump Speed Signal (P314A-828)

DESCRIPTION Refer to the description for DTC P0C73-776. Click here The inverter water pump assembly sends the inverter water pump speed (measured value) signal to the hybrid vehicle control ECU. If

SEE MORE:

 Tilt and Telescopic Manual Switch Circuit

DESCRIPTION Different voltage values are sent to the multiplex tilt and telescopic ECU by operating the tilt and telescopic switch. The multiplex tilt and telescopic ECU then judges which motor and in which direction that motor should operate based on the voltage value. WIRING DIAGRAM PROCEDURE

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspe

© 2016-2026 Copyright www.lexunx.com