Lexus NX: Components
Lexus NX Service Manual / Vehicle Exterior / Wiper / Washer / Washer Level Warning Switch / Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT FENDER FRONT SPLASH SHIELD RH | *2 | FRONT FENDER LINER RH |
| *3 | FRONT FENDER MOULDING SUB-ASSEMBLY RH | *4 | LEVEL WARNING SWITCH ASSEMBLY |
| *5 | NO. 1 MOULDING TAPE | *6 | NO. 2 MOULDING TAPE |
| *7 | GROMMET | - | - |
| ● | Non-reusable part | - | - |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL RH Click here 2. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH HINT: Use the same procedure described for the LH side. Click here 3. REMOVE NO. 1 MOULDING TA
Inspection
INSPECTION PROCEDURE 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY *a Component without harness connected (Level Warning Switch Assembly) HINT: The following check should be performed with the lev
Installation
INSTALLATION PROCEDURE 1. INSTALL LEVEL WARNING SWITCH ASSEMBLY (a) Install the level warning switch assembly as shown in the illustration. NOTICE: Make sure that the protrusion of the level warnin
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT PROCEDURE 1. INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH HINT: When installing the quarter outside moulding sub-assembly LH, heat the vehicle body and quarter outside moulding sub-assembly LH using a heat light. Standard: Item Temperature Vehicle B
GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) (B1575)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area B1575 GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) GVIF disconnected (from radio receiver assembly to multi-display assembly)
Harness or connector (GVIF cable)
Multi-display assembly
© 2016-2026 Copyright www.lexunx.com
