Lexus NX: Components
Lexus NX Service Manual / Vehicle Interior / Seat Belt / Front Seat Inner Belt Assembly / Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT SEAT INNER BELT ASSEMBLY LH | *2 | FRONT SEAT INNER BELT ASSEMBLY RH |
| *3 | FRONT SEAT BELT ANCHOR PLATE | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH Click here 2. REMOVE FRONT SEAT ASSEMBLY RH HINT: Use the same procedure as for the driver seat. 3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (a) D
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (a) Measure the resistance according to the value(s) in the table below. *1 Connector A *2 Connector B *3 Connector C
Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (a) Install the front seat belt anchor plate. (b) Install the front seat inner belt assembly LH with the nut. Torque: 42 N·m {4
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE MULTI-DISPLAY ASSEMBLY Click here 2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. REMOVE REAR CONSOLE ARMREST ASSEMBLY Click here 5. REMOVE UPPER REAR CONSOLE PANEL Click here 6. REMOVE UPPER NO. 1 CONSOLE P
System Description
SYSTEM DESCRIPTION MULTI CHANNEL FUNCTION (a) The electrical key transmitter sub-assembly and door control receiver can operate on two different RF channels. When an electrical key transmitter sub-assembly is brought within an exterior detection area, key verification begins. If key verification fai
© 2016-2026 Copyright www.lexunx.com
