Lexus NX: Front Seat Inner Belt Assembly

Lexus NX Service Manual / Vehicle Interior / Seat Belt / Front Seat Inner Belt Assembly

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 FRONT SEAT INNER BELT ASSEMBLY LH *2 FRONT SEAT INNER BELT ASSEMBLY RH *3 FRONT SEAT BELT ANCHOR PLATE - - N*m (kgf*cm, ft.*lbf): Specified torque

 Removal

REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH Click here 2. REMOVE FRONT SEAT ASSEMBLY RH HINT: Use the same procedure as for the driver seat. 3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (a) D

 Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (a) Measure the resistance according to the value(s) in the table below. *1 Connector A *2 Connector B *3 Connector C

SEE MORE:

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH HINT: When removing the rear door lower outside moulding sub-assembly LH, heat the rear

 Parts Location

PARTS LOCATION ILLUSTRATION *A for 2WD *B for AWD *1 AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY (AIR CONDITIONER PRESSURE SENSOR) *2 THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR) *3 HEATER ACCESSORY ASSEMBLY *4 PTC HTR NO.1 RELAY *5 PTC HTR NO.2 RELAY *6

© 2016-2024 Copyright www.lexunx.com