Lexus NX: Components
Lexus NX Service Manual / Vehicle Interior / Seat Belt / Front Seat Outer Belt Assembly / Components
COMPONENTS
ILLUSTRATION
| *1 | DECK FLOOR BOX LH | *2 | NO. 3 DECK BOARD SUB-ASSEMBLY |
| *3 | REAR DECK FLOOR BOX | *4 | NEGATIVE AUXILIARY BATTERY TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | DOOR SCUFF PLATE ASSEMBLY LH | *2 | FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| *3 | REAR DOOR OPENING TRIM WEATHERSTRIP RH | *4 | REAR DOOR SCUFF PLATE LH |
ILLUSTRATION
| *1 | CENTER PILLER GARNISH ASSEMBLY LH | *2 | FRONT SEAT OUTER BELT ASSEMBLY LH |
| *3 | FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY | *4 | FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH |
| *5 | LAP BELT OUTER ANCHOR COVER | *6 | LOWER CENTER PILLAR GARNISH LH |
| | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the front seat outer belt assembly. PROCEDURE 1. INSPECT FRONT SEAT OUTER
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (a) Before installing the front seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) When t
Rear Center Seat Outer Belt Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 SEAT BELT ANCHOR COVER N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. RE
SEE MORE:
Transmission Control Switch Circuit
DESCRIPTION When the shift lever is in S, different ranges can be chosen using the floor shift sequential gate. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (SPORTS MODE) (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Enter the following menus: Po
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT CONTROL ECU ASSEMBLY (a) Disconnect the stop light control ECU assembly connector. *a Front view of wire harness connector (to Stop Light Control ECU Assembly) (b) Measure the voltage and resistance on the wire harness
© 2016-2025 Copyright www.lexunx.com
