Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH
Click here .gif)
2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH
Click here
3. REMOVE REAR FLOOR SIDE MEMBER COVER
Click here
4. REMOVE REAR BUMPER COVER
Click here
5. REMOVE ELECTRICAL KEY ANTENNA
NOTICE:
Do not reuse dropped or damaged parts.
| (a) Disconnect the connector and remove the nut. |
|
(b) Detach the guide and remove the electrical key antenna.
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL ELECTRICAL KEY ANTENNA NOTICE: Do not reuse dropped or damaged parts. (a) Attach the guide and install the electrical key antenna with the nut. Torque: 7.5 N·m {76
Electrical Key Oscillator(for Rear Floor)
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 2 CONSOLE BOX MOUNTING BRACKET *2 NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREM
Engine Hood Courtesy Switch
ComponentsCOMPONENTS ILLUSTRATION *1 HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) *2 RADIATOR SUPPORT OPENING COVER N*m (kgf*cm, ft.*lbf) : Specified torque MP grease Re
SEE MORE:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use these procedures to troubleshoot the lane tracing assist system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. INSPECT AUXILIARY BATTERY VOLTAGE (a) Measure the auxiliary battery voltage with the p
Parts Location
PARTS LOCATION ILLUSTRATION *1 NO. 2 ENGINE ROOM RELAY BLOCK - DCM FUSE *2 TELEPHONE AND GPS ANTENNA (ROOF ANTENNA ASSEMBLY) ILLUSTRATION *1 TELEPHONE ANTENNA (NAVIGATION ANTENNA ASSEMBLY) *2 COMBINATION METER ASSEMBLY *3 MULTI-DISPLAY ASSEMBLY *4 DCM (TELEMATICS TRA
© 2016-2026 Copyright www.lexunx.com
