Lexus NX manuals

Lexus NX: Installation

Lexus NX Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Electrical Key Oscillator (for Outside Luggage Compartment) / Installation

INSTALLATION

PROCEDURE

1. INSTALL ELECTRICAL KEY ANTENNA

NOTICE:

Do not reuse dropped or damaged parts.

(a) Attach the guide and install the electrical key antenna with the nut.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

(b) Connect the connector.

2. INSTALL REAR BUMPER COVER

Click here

3. INSTALL REAR FLOOR SIDE MEMBER COVER

Click here

4. INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH

Click here

5. INSTALL QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH

Click here

READ NEXT:

 Electrical Key Oscillator(for Rear Floor)

ComponentsCOMPONENTS ILLUSTRATION *1 NO. 2 CONSOLE BOX MOUNTING BRACKET *2 NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREM

 Engine Hood Courtesy Switch

ComponentsCOMPONENTS ILLUSTRATION *1 HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) *2 RADIATOR SUPPORT OPENING COVER N*m (kgf*cm, ft.*lbf) : Specified torque MP grease Re

 Id Code Box

ComponentsCOMPONENTS ILLUSTRATION *1 AIR CONDITIONER UNIT ASSEMBLY *2 ID CODE BOX (IMMOBILIZER CODE ECU) InstallationINSTALLATION PROCEDURE 1. INSTALL ID CODE BOX (IMMOBILIZER CODE ECU)

SEE MORE:

 Removal

REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the connector. (b) Loosen the lock

 Engine Hood Courtesy Switch Circuit

DESCRIPTION The engine hood courtesy switch is installed together with the hood lock. This switch turns on when the engine hood is closed and turns off when the engine hood is opened. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: If the main body ECU (multiplex network body ECU) is replaced, refer

© 2016-2026 Copyright www.lexunx.com