Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | for 2WD | *B | for AWD |
| *1 | HOOD LOCK ASSEMBLY | *2 | NO. 6 INVERTER BRACKET |
| *3 | UPPER RADIATOR SUPPORT SUB-ASSEMBLY | *4 | FRONT RADIATOR SIDE AIR GUIDE PLATE RH |
| *5 | FRONT RADIATOR SIDE AIR GUIDE PLATE LH | *6 | WIRE HARNESS |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for 2WD | *B | for AWD |
| *1 | LOWER RADIATOR SUPPORT | *2 | NO. 1 RADIATOR HOSE |
| *3 | NO. 2 FAN SHROUD | *4 | NO. 2 INVERTER COOLING HOSE |
| *5 | NO. 2 RADIATOR HOSE | *6 | NO. 2 WATER BY-PASS HOSE |
| *7 | NO. 4 INVERTER COOLING HOSE | *8 | NO. 5 INVERTER COOLING HOSE |
| *9 | RADIATOR SUPPORT CUSHION | *10 | WATER BY-PASS PIPE |
| *11 | RADIATOR SUPPORT | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | RADIATOR ASSEMBLY | *2 | FAN SHROUD WITH FAN |
| | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RESERVOIR CAP (a) Measure the valve opening pressure. *a O-Ring *b Rubber Packing (1) If there are water stains or foreign matter on the O-rin
Removal
REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY Click here 3. DISCONNECT HOOD LOCK ASSEMBLY (a) Detach the 2 clamps and disconnect the ho
Installation
INSTALLATION PROCEDURE 1. INSTALL LOWER RADIATOR SUPPORT (a) Install the 2 lower radiator supports to the fan shroud. 2. INSTALL RADIATOR SUPPORT CUSHION (a) Install the 2 radiator support cushions to
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the fuel pump. Click here PROCEDURE 1. INSTALL FUEL SUCTION TUBE ASSEMBLY (a) Install a new gasket onto the fuel suction tube assembly. (b) With the paint mark facing the top of the vehicle, connect th
Components
COMPONENTS ILLUSTRATION *1 COOLER CONDENSER ASSEMBLY *2 COOLER DRYER *3 DISCHARGE HOSE SUB-ASSEMBLY *4 LIQUID PIPE SUB-ASSEMBLY *5 NO. 1 COOLER CONDENSER CUSHION *6 O-RING *7 CAP - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part
© 2016-2026 Copyright www.lexunx.com
