Lexus NX: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE SEAT BELT WARNING SYSTEM
HINT:
The following items can be customized.
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Record the current settings before customizing.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Warning.
(5) Select the setting by referring to the table below.
Warning| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Driver Side Seatbelt Warning Buzzer | Function to sound the driver seat belt warning buzzer | ON | 0:OFF,1:ON | Combination meter assembly |
| Front Passenger Side Seatbelt Warning Buzzer | Function to sound the front passenger seat belt warning buzzer | ON | 0:OFF,1:ON | Combination meter assembly |
HINT:
This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to the Smart Access System with Push-button Start (for Entry Function). Click here HINT:
Use
Terminals Of Ecu
TERMINALS OF ECU CHECK COMBINATION METER ASSEMBLY (a) Disconnect the I10 combination meter assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below.
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT AUXILIARY BATTERY VOLTAGE (a) Measure the auxiliary battery voltage. Standard voltage: 11 to 14 V (power switch off) If the vo
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY NOTICE: Do not touch the cone part of the speaker. (a) Attach the 3 claws to install the rear No. 2 speak
Installation
INSTALLATION PROCEDURE 1. INSTALL AUXILIARY BATTERY (a) Install the auxiliary battery. (b) Install the battery insulator to the auxiliary battery. (c) Install the L-shaped pipe section to the auxiliary battery without twisting the battery hose. HINT: Insert the auxiliary battery hose
