Lexus NX: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Immobiliser System

DTC No.

Detection Item

Link

B2779

Engine Starter Communication Malfunction

B2784

Antenna Coil Open / Short

B278A

Short to GND in Immobiliser System Power Source Circuit

B2790

ID BOX EEPROM Malfunction

B2799-790

Engine Immobiliser System Malfunction

B279A-186

Engine Immobiliser System Communication Line High Fixation

B279C-185

Engine Immobiliser System Presence Detection

READ NEXT:

 Engine Starter Communication Malfunction (B2779)

DESCRIPTION If the remote engine start ECU does not respond to the certification ECU (smart key ECU assembly) or the remote engine start ID is not registered*, this DTC is stored. If communication bet

 Antenna Coil Open / Short (B2784)

DESCRIPTION When an open or short circuit is detected in the transponder key amplifier coil built into the power switch, the certification ECU (smart key ECU assembly) stores this DTC. This DTC is als

 Short to GND in Immobiliser System Power Source Circuit (B278A)

DESCRIPTION When there is a short to GND in the power supply for the transponder key amplifier of the power switch, the certification ECU (smart key ECU assembly) stores this DTC. DTC No. Detecti

SEE MORE:

 Blind Spot Monitor Sensor

RemovalREMOVAL CAUTION / NOTICE / HINT NOTICE: Avoid any impact to the blind spot monitor sensor. Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one. PROCEDURE 1. REMOVE REAR BUMPER COVER Click here 2. REMOVE BLIND SPOT MONITOR SENSOR LH (a) Remove the

 Removal

REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE REAR SPOILER ASSEMBLY (a) Remove the 2 hole plugs. Nut Bolt Connector (b) Remove the 4 nuts. (c) Remove the 2 bolts. (d) Disconnect the 2 connectors. (e) Put protective tape around the rear spoile

© 2016-2025 Copyright www.lexunx.com