Lexus NX: Software Incompatibility with Body Control Module Invalid/Incompatible Software Component (U032257)
DESCRIPTION
If the vehicle information stored in the forward recognition camera does not match the vehicle information sent from the main body ECU (multiplex network body ECU), the forward recognition camera stores DTC U032257.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U032257 | Software Incompatibility with Body Control Module Invalid/Incompatible Software Component | The vehicle information sent from the main body ECU (multiplex network body ECU) does not match that stored in the forward recognition camera. | Front camera system | Forward recognition camera |
PROCEDURE
| 1. | GO TO FRONT CAMERA SYSTEM |
HINT:
If DTC U032257 is output by the dynamic radar cruise control system, perform troubleshooting for the front camera system.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Invalid Data Received from Hybrid Powertrain Control Module Invalid Serial Data Received (U059481)
DESCRIPTION If the hybrid vehicle control ECU cannot recognize the forward recognition camera. DTC U059481 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output
Cruise Control Switch Circuit
DESCRIPTION
The cruise control main switch outputs the cruise control power supply switch signal and each operation switch signal to the hybrid vehicle control ECU.
The hybrid vehicle control ECU
Distance Control Switch Circuit
DESCRIPTION The vehicle-to-vehicle distance control switch is used to set the distance for vehicle-to-vehicle distance control mode. The vehicle-to-vehicle distance control switch is installed in the
SEE MORE:
Tire And Wheel
RemovalREMOVAL PROCEDURE 1. REMOVE WHEEL ASSEMBLY (a) Loosen the axle hub nuts approximately 90°. (b) Lift up the vehicle and remove the axle hub nuts and wheel assembly. InstallationINSTALLATION PROCEDURE 1. INSTALL WHEEL ASSEMBLY NOTICE:
Only use axle hub nuts that are compatible with the wh
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY Click here 2. REMOVE ROOF RACK ASSEMBLY (a) Remove the 5 nuts and roof rack assembly.
