Lexus NX: Immobiliser System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Registration
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Engine Starter Communication Malfunction (B2779)
- Antenna Coil Open / Short (B2784)
- Short to GND in Immobiliser System Power Source Circuit (B278A)
- ID BOX EEPROM Malfunction (B2790)
- Engine Immobiliser System Malfunction (B2799-790)
- Engine Immobiliser System Communication Line High Fixation (B279A-186)
- Engine Immobiliser System Presence Detection (B279C-185)
- Security Indicator Light Does not Blink
- Immobiliser System does not Operate Properly
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE:
After the power switch is turned off, there may be a waiting time before disconnecting the negative (-
Parts Location
PARTS LOCATION ILLUSTRATION *1 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY - AM2 FUSE - STRG LOCK FUSE *2 NO. 2 ENGINE ROOM RELAY BLOCK AND NO. 2 JUNCTION BLOCK ASSEMBLY
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Operation Check
OPERATION CHECK ICS OFF INDICATOR LIGHT OPERATION CHECK (a) Turn the power switch on (IG). (b) Turn the intelligent clearance sonar system off and confirm that the ICS OFF indicator in the combination meter illuminates. HINT: If the intelligent clearance sonar system is not set to off in the custom
Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING GEAR ASSEMBLY (a) Install the steering gear assembly to the front suspension crossmember with the 2 bolts and 2 nuts. Torque: 110 N·m {1122 kgf·cm, 81 ft·lbf} NOTICE:
Make sure to tighten the bolts starting from the left side of the vehicle.
Becaus
© 2016-2026 Copyright www.lexunx.com
