Lexus NX: Disassembly
DISASSEMBLY
PROCEDURE
1. PRECAUTION
NOTICE:
-
Be sure to read Precaution thoroughly before servicing.
Click here
.gif)
- Do not reuse parts which have reduced fastening ability due to thread damage.
- When installing components, make sure that the wire harness is not pinched or pulled.
- Do not use solvent to clean components. Only clean them with a dry cloth.
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY LH
Click here
3. REMOVE HEADLIGHT GASKET
Click here
READ NEXT:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
It is possible that a headlight assembly is incorrectly i
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE:
Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.
Do not reuse parts
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. INSTALL HEADLIGHT ASSEMBLY LH (a) Conn
SEE MORE:
Main Body ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Main Body ECU Communication Stop Mode Any of the following conditions are met:
Communication stop for "Main Body" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Communication system DTCs (DTCs t
Stop Light Relay Circuit (C1A4B)
DESCRIPTION When a stop light relay circuit malfunction signal sent from the pre-collision system is detected by the clearance warning ECU assembly, DTC C1A4B is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C1A4B Stop Light Relay Circuit Stop light relay circu
© 2016-2026 Copyright www.lexunx.com
