Lexus NX: Headlight Assembly (for Triple Beam Headlight)

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Headlight Assembly (for Triple Beam Headlight)

READ NEXT:

 Precaution

PRECAUTION NOTICE: When disassembling the headlight assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by ele

 Components

COMPONENTS ILLUSTRATION *1 HEADLIGHT ASSEMBLY LH - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 HEADLIGHT ECU SUB-ASSEMBLY LH *2 HEADLIGHT GASKET

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (a) except Spo

SEE MORE:

 System Diagram

SYSTEM DIAGRAM Communication Table Sender Receiver Signal Communication Line Air conditioning amplifier assembly Hybrid vehicle control ECU Heater idle up request signal CAN ECO mode switch information signal Engine ON request signal Charging control inhibit sign

 Drive Motor "A" Inverter Voltage Sensor Circuit Low (P0D2F-266,P0D30-267)

DESCRIPTION The inverter contains a three-phase bridge circuit, which consists of 6 power transistors (IGBTs) each for the generator (MG1), motor (MG2) and rear motor (MGR). The inverter converts high-voltage direct current from the HV battery into three-phase alternating current for the generator (

© 2016-2022 Copyright www.lexunx.com