Lexus NX: Disc cannot be Ejected

Lexus NX Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System / Disc cannot be Ejected

CAUTION / NOTICE / HINT

NOTICE:

When replacing the radio receiver assembly, always replace it with a new one.

If a radio receiver assembly which was installed to another vehicle is used, the following may occur:

A communication malfunction DTC may be stored.
The radio receiver assembly may not operate normally.

HINT:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE

1.	CHECK OPERATION

(a) Press the disc eject switch of the radio receiver assembly for 5 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.

REPLACE RADIO RECEIVER ASSEMBLY

2.	REPLACE DISC AND RECHECK

(a) Replace the disc with a known good one and check that the malfunction disappears.

OK:

Disc is ejected.

END (DISC IS DEFECTIVE)

REPLACE RADIO RECEIVER ASSEMBLY

SEE MORE:

For your information

Main Owner's Manual Please note that this manual applies to all models and explains all equipment, including options. Therefore, you may find some explanations for equipment not installed on your vehicle. All specifications provided in this manual are current at the time of printing. How

Inspection

INSPECTION PROCEDURE 1. INSPECT OUTER MIRROR LH (a) Check the outer mirror heater operation. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 25°C (77°F) 6.8 to 10.2 Ω If the r

Lexus NX: Disc cannot be Ejected

READ NEXT:

CD/DVD Sound Skips

Radio Broadcast cannot be Received or Poor Reception

Illumination for Panel Switch does not Come on with Tail Switch ON

SEE MORE:

For your information

Inspection