Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Afs (adaptive Front-lighting System) / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / AFS / Trouble Codes.
Body Electrical > AFS > Trouble Codes(e) Check for DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / AFS / Trouble Codes.
Body Electrical > AFS > Clear DTCs(e) Clear the DTCs.
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever an automatic headlight beam level control system DTC is stored, the headlight ECU subassembly LH stores the current vehicle state as freeze frame data.
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART AFS (Adaptive Front-Lighting System) DTC No. Detection Item Link B2410 Headlight Swivel ECU LH Communication B2411 Headlight Swivel ECU RH Communi
SEE MORE:
Calibration
CALIBRATION TORQUE SENSOR ZERO POINT CALIBRATION (USING THE Techstream) NOTICE: Perform torque sensor zero point calibration if any of the following conditions occur:
The power steering ECU assembly has been replaced.
The electric power steering column sub-assembly has been replaced.
There is
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the EGR valve assembly. Click here PROCEDURE 1. INSTALL EGR VALVE ASSEMBLY HINT: Perform "Inspection After Repair" after replacing the EGR valve assembly. Click here (a) Install 2 new gaskets to the N
© 2016-2026 Copyright www.lexunx.com
