Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Automatic High Beam System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Body Electrical > Main Body > Trouble Codes(e) Check for DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes.
Body Electrical > Main Body > Clear DTCs(e) Clear the DTCs.
READ NEXT:
Fail-safe Chart
FAIL-SAFE CHART AUTOMATIC HIGH BEAM SYSTEM (a) The main body ECU (multiplex network body ECU) operates in fail-safe mode if an abnormal condition such as those listed below has been detected. Item
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Automatic High Beam System DTC No. Detection Item Link B124B Automatic High Beam System B124C Automatic High Beam Camera U023A Lost Com
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (a) Measure the resistance according to the value(s) in the table below. *1 Connector A *2 Connector B *3 Connector C - - *a Component without harness connected (Front Seat Inner Belt Assembly LH) - -
Short in P/T Squib (LH) Circuit (B1905-B1908)
DESCRIPTION The front pretensioner LH circuit consists of the airbag ECU assembly and front seat outer belt assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front pretensioner LH circuit. DTC No.
© 2016-2026 Copyright www.lexunx.com
