Lexus NX: Automatic High Beam System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Automatic High Beam System (B124B)
- Automatic High Beam Camera (B124C)
- Lost Communication with Front Camera Module (U023A)
- Automatic High Beam System does not Operate or Operation Indicator does not Illuminate
READ NEXT:
Precaution
PRECAUTION HANDLING PRECAUTIONS FOR FORWARD RECOGNITION CAMERA (a) The automatic high beam system uses the forward recognition camera. For precautions related to the forward recognition camera, refer
Parts Location
PARTS LOCATION ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (SKID CONTROL ECU) *3 HEADLIGHT ASSEMBLY LH *4 HEADLIGHT ASSEMBLY RH *5
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Steering Angle Sensor Failure (C1626)
DESCRIPTION This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area C1626 Steering Angle Sensor Failure A fail flag is transmitte
Illumination for Panel Switch does not Come on with Tail Switch ON
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
© 2016-2026 Copyright www.lexunx.com
