Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System (for Single Beam Headlight) / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main body / Trouble Codes.
Body Electrical > Main Body > Trouble Codes(e) Body Electrical / Front Recognition Camera (Front Lighting Control) / Trouble Codes.
Body Electrical > Front Recognition Camera (Front Lighting Control) > Trouble Codes(f) Check for DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Clear DTCs.
Body Electrical > Main Body > Clear DTCs(e) Body Electrical / Front Recognition Camera (Front Lighting Control) / Clear DTCs.
Body Electrical > Front Recognition Camera (Front Lighting Control) > Clear DTCs(f) Clear the DTCs.
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a lighting system DTC is stored, the forward recognition camera stores the current vehicle state as freeze frame data. CHECK FREEZE FRAME DATA (a) Conn
Fail-safe Chart
FAIL-SAFE CHART LED HEADLIGHT SYSTEM The headlight assembly (light control LED ECU) operates in fail-safe mode if any of the following abnormalities are detected. Item Abnormality Detection Condi
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL SHIFT LEVER ASSEMBLY (a) Temporarily install the shift lever assembly with the 4 bolts. (b) Tighten the bolts in the order shown in the illustration. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf} (c) Install the nut to the shift lever assembly. (d) Connec
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL INJECTOR ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 11.6 to 12.4 Ω If the result is not as specified, replace the f
© 2016-2026 Copyright www.lexunx.com
