Lexus NX manuals

Lexus NX: Dtc Check / Clear

Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System) / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the intuitive parking assist system on.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Trouble Codes.

(f) Check for DTCs.

Click here

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the intuitive parking assist system on.

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Trouble Codes.

(f) Clear the DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

READ NEXT:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Intuitive Parking Assist System DTC No. Detection Item Link C1AE1 Front Left Sensor Malfunction C1AE2 Front Left Center Sensor C1AE3 Fr

 Front Left Sensor Malfunction (C1AE1)

DESCRIPTION The front corner ultrasonic sensor (FL sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultras

SEE MORE:

 Pattern Select Switch Eco Mode Circuit

DESCRIPTION When selecting ECO mode, the mode switch (integration control & panel assembly) operation signal is sent to the air conditioning amplifier assembly. Following this, ECO mode control is activated for the heater and air conditioning system. WIRING DIAGRAM PROCEDURE 1. READ VALUE

 Removal

REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door) Click here 5. REMOVE PULL HANDLE (w/ Power Back Door) Click here 6. REMOVE B

© 2016-2026 Copyright www.lexunx.com