Lexus NX: Engine Coolant Temperature Sensor
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (engine Control) / Engine Coolant Temperature Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 ENGINE COOLANT TEMPERATURE SENSOR *2 NO. 1 ENGINE COVER SUB-ASSEMBLY *3 GROUND WIRE *4 GASKET N*m (kgf*cm, ft.*lbf) : Specified torque * For u
Removal
REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR (a) Disconnect the engine coolant tempera
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR *a Component without harness connected (Engine Coolant Temperature Sensor) *b Resistance *c Temperature *d Accepta
SEE MORE:
Control Module Communication Bus Off (U0073,U0100,U0126,U0129,U0140,U0163,U0233,U0265-U0268,U1110)
DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU. HINT: If CAN communication system DTCs are stored, they may also be stored in other systems. DTC No. Detection Item DTC Detection Condition Trouble Area U0073
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY (a) Install the outer mirror control ECU assembly with the 2 screws. (b) Connect the 2 connectors.
© 2016-2025 Copyright www.lexunx.com
