Lexus NX: Fail-safe Chart
Lexus NX Service Manual / Vehicle Exterior / Wiper / Washer / Wiper And Washer System / Fail-safe Chart
FAIL-SAFE CHART
FAIL-SAFE FUNCTION (w/ Rain Sensor)
(a) When the windshield wiper switch assembly is in the AUTO position and any of the following conditions are met, intermittent operation according to the sensitivity setting is performed.
(1) Rain sensor output malfunction
(b) When the windshield wiper switch assembly is in the AUTO position and any of the following conditions are met, the wiper operation stops.
(1) After a wiper operation output, the wiper motor position cannot be detected for 20 seconds.
(2) Rain sensor high temperature malfunction (90°C [194°F] or higher).
(3) Rain sensor low temperature malfunction (-15°C [5°F] or lower).
(c) When the washer switch is on for 32 seconds or more, the washer operation stops.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
Headlight Cleaner Motor and Relay Circuit
DESCRIPTION The headlight ECU sub-assembly RH controls the headlight cleaner motor and pump assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
First check that the front washer operates norm
Washer Fluid Level Warning Switch Circuit
DESCRIPTION When the volume of washer fluid decreases to below a certain level (when the level warning switch assembly is turned on), the multi-information display warns the driver by displaying a mes
SEE MORE:
Hybrid Powertrain Control Module (P0A1D-187)
DESCRIPTION The hybrid vehicle control ECU monitors its internal operation, it will store a DTC and perform fail-safe control if it detects the following malfunction. If the following DTC is output, replace the hybrid vehicle control ECU. DTC No. Detection Item DTC Detection Condition Troub
Initialization
INITIALIZATION INITIALIZE PARKING ASSIST MONITOR SYSTEM (a) When the "!" mark is displayed on the multi-display assembly, correct the steering angle neutral point using the following method. (1) Fully turn the steering wheel to the right and left on flat ground. NOTICE: Memorizing the steering angle
© 2016-2026 Copyright www.lexunx.com
