Lexus NX: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Combination Meter or AFS* / Data List.
- *: w/ Headlight Cleaner System, for Triple Beam Headlight
(f) According to the display on the Techstream, read the Data List.
Body Electrical > Combination Meter > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Washer Switch | Level warning switch condition | ON/OFF | ON: Fluid volume is less than 600 to 800 cc (36.6 to 48.8 cu.in.) OFF: Fluid volume is more than 600 to 800 cc (36.6 to 48.8 cu.in.) | - |
| Tester Display | Measurement Item | Type | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Front Window Washer Switch | Washer switch condition | ON/OFF | ON: Windshield wiper switch assembly (front washer switch) on OFF: Windshield wiper switch assembly (front washer switch) off | w/ Headlight Cleaner System |
READ NEXT:
Headlight Cleaner Motor and Relay Circuit
DESCRIPTION The headlight ECU sub-assembly RH controls the headlight cleaner motor and pump assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
First check that the front washer operates norm
Washer Fluid Level Warning Switch Circuit
DESCRIPTION When the volume of washer fluid decreases to below a certain level (when the level warning switch assembly is turned on), the multi-information display warns the driver by displaying a mes
SEE MORE:
Manifold Absolute Pressure Circuit Problem (P0106)
DESCRIPTION The manifold absolute pressure sensor detects pressure inside the intake manifold as an absolute pressure with a built-in sensor and outputs it as voltage. Based on the voltage from the manifold absolute pressure sensor, the ECM controls the purge VSV and corrects any errors in the air
Inside rear view mirror
The rear view mirror's position can
be adjusted to enable sufficient
confirmation of the rear view.
Adjusting the height of rear view
mirror
The height of the rear view mirror can
be adjusted to suit your driving posture.
Adjust the height of the rear view mirror
by moving it up and down.
