Lexus NX: Washer Fluid Level Warning Switch Circuit
DESCRIPTION
When the volume of washer fluid decreases to below a certain level (when the level warning switch assembly is turned on), the multi-information display warns the driver by displaying a message.
WIRING DIAGRAM
.png)
CAUTION / NOTICE / HINT
NOTICE:
When replacing the combination meter assembly, make sure to replace it with a new one.
PROCEDURE
| 1. | READ VALUE USING TECHSTREAM |
(a) Read the Data List according to the display on the Techstream.
Click here .gif)
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Washer Switch | Level warning switch condition | ON/OFF | ON: Fluid volume is less than 600 to 800 cc (36.6 to 48.8 cu.in.) OFF: Fluid volume is more than 600 to 800 cc (36.6 to 48.8 cu.in.) | - |
| Tester Display |
|---|
| Washer Switch |
OK:
On the Techstream screen, ON or OFF is displayed accordingly.
| OK | .gif) | GO TO METER / GAUGE SYSTEM |
|
.gif)
| 2. | INSPECT LEVEL WARNING SWITCH ASSEMBLY |
(a) Disconnect the A22 level warning switch assembly connector.
(b) Inspect the level warning switch assembly.
Click here
| NG | | REPLACE LEVEL WARNING SWITCH ASSEMBLY |
|
| 3. | CHECK HARNESS AND CONNECTOR (LEVEL WARNING SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND) |
(a) Disconnect the A22 level warning switch assembly connector.
(b) Disconnect the I10 combination meter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A22-1 (S) - I10-16 (WLVL) | Always | Below 1 Ω |
| A22-2 (E) - Body ground | Always | Below 1 Ω |
| A22-1 (S) or I10-16 (WLVL) - Body ground | Always | 10 kΩ or higher |
| OK | | REPLACE COMBINATION METER ASSEMBLY |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precoution thoroughly before serving. Click here NOTICE: After the power switch is turned off, there may be a waiting time before disconnecti
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING ASSIST ECU (a) Temporarily install a new nut (A) so that the nut cannot fall, but do not tighten it. *a Nut A *b Nut B Connector (b) Connect the 3 connectors. (c) Insert nut (A) into the hole in the body and slide downward to temporaril
Display Malfunction (B15A6,B15B0)
DESCRIPTION These DTCs are stored when a malfunction occurs in the multi-display assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15A6 Display Malfunction When one of the conditions below is met:
RAM error
Drawing controller malfunction
Multi-display
