Lexus NX: Front Power Seat Control System(w/o Memory)
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 NO. 2 ENGINE ROOM RELAY BLOCK
- P/SEAT F/R FUSE
*2 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- P/SEAT F/L FUSE
ILLUSTRATION *A for Driver S
System Diagram
SYSTEM DIAGRAM
Operation Check
OPERATION CHECK CHECK POWER SEAT FUNCTION *A for Driver Side *a Slide Function *b Reclining Function *c Rear Lifter Function *d Front Vertical Function *e Lumbar Su
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 2 ROOF CARRIER PROTECTOR (a) Clean the roof rack surface. (1) Remove the double-sided tape from the roof rack. (2) Wipe off any tap
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the Techstream on. (c) Put the engine in inspection mode (maintenance mode). Click here (d) Start the engine. (e) Warm up the engine. (f) Enter the following menus
© 2016-2026 Copyright www.lexunx.com
