Lexus NX: Fuel Lid Opener Motor Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK TRIM SIDE PANEL ASSEMBLY LH *2 FUEL FILLER OPENING LID LOCK RETAINER *3 FUEL LID WITH MOTOR LOCK ASSEMBLY *4 LUGGAGE HOLD BELT STRIKER ASSEMBLY
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) for Power Seat: Click here (b) for Manual Seat: Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. DISCONNECT REAR DOOR OPENING TR
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL LID WITH MOTOR LOCK ASSEMBLY (a) Check the operation of the fuel lid with lock motor assembly. (1) Apply auxiliary battery voltage to the fuel lid with motor lo
SEE MORE:
Absorber Control Actuator (for Rear Side)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ABSORBER CONTROL ACTUATOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: for LH Side Tester Connection Condition Specified Condition 1 (+) - 3 (-) 15 to 25°C 2.8 to 4.4
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY (a) Attach the 2 guides as shown in the illustration to install the roof wind deflector panel sub-assembly. (b) Attach the 2 springs as shown in the illustration. *a Spring - - NOTICE: Make sure that the springs are
© 2016-2026 Copyright www.lexunx.com
