Lexus NX: Headlight Dimmer Switch

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau

 Inspection

INSPECTION PROCEDURE 1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (a) Inspect the light control switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:

SEE MORE:

 Invalid Data Received from Deceleration Sensor (C1442,C1443)

DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via the CAN communication system. The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

 Combination Meter ECU Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Combination Meter ECU Communication Stop Mode Any of the following conditions are met: Communication stop for "Combination Meter" is indicated on the "Communication Bus Check" screen of the Techstream. Click here Communication sys

© 2016-2026 Copyright www.lexunx.com