Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY
(a) Attach the 2 claws to install the headlight dimmer switch assembly.
(b) Connect the connector.
2. INSTALL TILT AND TELESCOPIC SWITCH
Click here .gif)
3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
Click here
4. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Click here
5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Connect the auxiliary battery negative (-) terminal and tighten the nut.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
6. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
7. INSTALL DECK FLOOR BOX LH
Click here
8. INSTALL REAR DECK FLOOR BOX
Click here
9. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
10. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
11. CHECK SRS WARNING LIGHT
Click here
READ NEXT:
Precaution
PRECAUTION NOTICE: When disassembling the headlight assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by ele
Components
COMPONENTS ILLUSTRATION *A for Single Beam Headlight - - *1 HEADLIGHT ASSEMBLY LH *2 HEADLIGHT ECU SUB-ASSEMBLY LH *3 HEADLIGHT GASKET - - ● Non-reusable part -
SEE MORE:
Blower Motor Circuit
DESCRIPTION The blower with fan motor sub-assembly is operated by signals from the air conditioning amplifier assembly. Blower motor speed signals are transmitted in accordance with changes in the duty ratio. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Inspect the fuses for circuits related t
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Tilt & Telescopic / Trouble Codes. Body Electrical > Tilt&Telescopic > Trou
