Lexus NX: Hood Lock Control Cable Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CENTER HOOD CUSHION *2 HOOD LOCK ASSEMBLY *3 HOOD LOCK CONTROL CABLE ASSEMBLY *4 HOOD TO FRONT FENDER SEAL LH *5 RADIATOR SUPPORT OPENING COVER -
Removal
REMOVAL PROCEDURE 1. REMOVE RADIATOR SUPPORT OPENING COVER Click here 2. REMOVE HOOD LOCK ASSEMBLY Click here 3. REMOVE CENTER HOOD CUSHION (a) Detach the 2 claws and remove the center hood cush
Installation
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (a) Tie the string that was passed through the engine compartment room to the end of the hood lock control cable assembly as shown
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power swi
Inspection
INSPECTION PROCEDURE 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY *a Component without harness connected (Level Warning Switch Assembly) HINT: The following check should be performed with the level warning switch assembly installed to the windshield washer jar assembly. (a) Fill the windshield
© 2016-2026 Copyright www.lexunx.com
