Lexus NX manuals

Lexus NX: Inspection

Lexus NX Service Manual / Vehicle Exterior / Wiper / Washer / Rain Sensor / Inspection

INSPECTION

PROCEDURE

1. INSPECT MAP LIGHT ASSEMBLY (RAIN SENSOR CIRCUIT)

(a) Remove the map light assembly.

Click here

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

T6-1 (IG) - T6-14 (IG2)

Always

Below 1 Ω

T6-21 (GND2) - T6-19 (GND)

If the result is not as specified, replace the map light assembly.

*a

Component without harness connected

(Map Light Assembly (Rain Sensor Circuit))

(c) Install the map light assembly.

Click here

READ NEXT:

 Installation

INSTALLATION PROCEDURE 1. INSTALL RAIN SENSOR TAPE NOTICE: The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated. (a) Clean the rain sensor sensing portion with a pi

 Rear Wiper Motor

 Components

COMPONENTS ILLUSTRATION *A w/ Woofer *B w/o Woofer *C w/o Power Back Door *D w/ Power Back Door *1 BACK DOOR CENTER GARNISH *2 BACK DOOR FINISH COVER LH *3 BACK DOO

SEE MORE:

 Removal

REMOVAL PROCEDURE 1. REMOVE DECK BOARD ASSEMBLY Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 3. REMOVE REAR DECK FLOOR BOX Click here 4. REMOVE DECK FLOOR BOX LH Click here 5. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before serving. Click here NOTICE: Afte

 Yaw Rate Sensor (C1234,C1243-C1245,C1279)

DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication. The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition using 2 cir

© 2016-2026 Copyright www.lexunx.com