Lexus NX: Rain Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 RAIN SENSOR *2 RAIN SENSOR COVER *3 RAIN SENSOR TAPE - -
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here (b) Disconnect the rain sensor connector. *a Front view of wire harness connecto
Removal
REMOVAL PROCEDURE 1. REMOVE RAIN SENSOR COVER (a) Detach the 2 claws and remove the rain sensor cover. 2. REMOVE RAIN SENSOR (a) Disconnect the connector. (b) Release
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR REAR WINDOW FRAME MOULDING LH (a) Install a new rear door rear window frame moulding LH. (b) Install a nose piece to an air
Drive Motor "A" Inverter Voltage Sensor Circuit Low (P0D2F-266,P0D30-267)
DESCRIPTION The inverter contains a three-phase bridge circuit, which consists of 6 power transistors (IGBTs) each for the generator (MG1), motor (MG2) and rear motor (MGR). The inverter converts high-voltage direct current from the HV battery into three-phase alternating current for the generator (
© 2016-2025 Copyright www.lexunx.com
