Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure described below is for the LH side.
PROCEDURE
1. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH
(a) Attach the 2 claws to install the license plate light assembly LH.
(b) Connect the connector.
2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here
4. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
5. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
6. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
7. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)
Click here
8. INSTALL PULL HANDLE (w/ Power Back Door)
Click here
9. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
10. INSTALL BACK DOOR SIDE GARNISH LH
Click here
11. INSTALL BACK DOOR SIDE GARNISH RH
Click here
12. INSTALL CENTER BACK DOOR GARNISH
Click here
13. INSPECT LICENSE PLATE LIGHT
(a) Turn the power switch on (IG).
(b) Turn the headlight dimmer switch to the tail or head position and check that the license plate light illuminates.
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR HEADLIGHT BULB REPLACEMENT (a) If even a thin film of oil is left on the surface of a headlight bulb, its service life will be shortened because the light will burn at a high
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *2 SHIFT LEVER POSITION SENSOR *3 SIDE TURN SIGNAL LIGHT ASSEMBLY LH *4 SIDE TURN SIGNAL LIGHT ASSEMBLY
SEE MORE:
Drive Motor "A" Inverter Voltage Sensor Circuit Low (P0D2F-266,P0D30-267)
DESCRIPTION The inverter contains a three-phase bridge circuit, which consists of 6 power transistors (IGBTs) each for the generator (MG1), motor (MG2) and rear motor (MGR). The inverter converts high-voltage direct current from the HV battery into three-phase alternating current for the generator (
Immobiliser System does not Operate Properly
DESCRIPTION The immobiliser system compares the ID code that is registered in the certification ECU (smart key ECU assembly) with the ID code of the transponder chip that is embedded in the electrical key transmitter sub-assembly. WIRING DIAGRAM Click here CAUTION / NOTICE / HINT NOTICE:
When
