Lexus NX: Installation
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Stop Light Control Relay / Installation
INSTALLATION
PROCEDURE
1. INSTALL STOP LIGHT CONTROL ECU ASSEMBLY
(a) Attach the clamp to install the stop light control ECU assembly.
(b) Connect the connector.
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here .gif)
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
Click here
5. INSTALL REAR CONSOLE ARMREST ASSEMBLY
Click here
6. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
7. INSTALL INSTRUMENT SIDE PANEL LH
Click here
8. INSTALL COWL SIDE TRIM BOARD LH
Click here
9. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 DOOR SCUFF PLATE ASSEMBLY LH *3 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY *4 STOP LIGHT SWITCH ASSEMBLY *5 STOP LI
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. *a Front view of wire harness connector (to Stop Light
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply larger loads than necessary since the connector may be
Drive Motor "A" Control Module (P0A1B-503)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate that an overvoltage in the inverter has occurred. The cause of this malfunction may be one of the following: Internal inverter malfunction
Inverter internal circuit malfunction
Malfunction in ECU that controls the inverter
DESCRIPTION F
© 2016-2026 Copyright www.lexunx.com
