Lexus NX: Stop Light Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 DOOR SCUFF PLATE ASSEMBLY LH *3 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY *4 STOP LIGHT SWITCH ASSEMBLY *5 STOP LI
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. *a Front view of wire harness connector (to Stop Light
Removal
REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. R
SEE MORE:
Switch Operation of Remote Touch not Accepted
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Fuel Level Sensor "A" Circuit Range / Performance (P0461)
DESCRIPTION The fuel sender gauge is located inside the fuel tank and measures the amount of fuel. The fuel sender gauge converts the fuel level in the fuel tank into a output value, and outputs this value. The ECM determines when it is necessary to refuel the vehicle based on changes in the output
© 2016-2026 Copyright www.lexunx.com
