Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSMITTER BATTERY
Click here
2. INSTALL TRANSMITTER (CARD KEY) BATTERY
Click here
READ NEXT:
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After turning the power swi
SEE MORE:
DESCRIPTION Detection Item Symptom Trouble Area Headlight ECU Communication Stop Mode Any of the following conditions are met:
Communication stop for "Headlight swivel (AFS)" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Communication system
DESCRIPTION There may be a short circuit between the CAN main bus wire and/or CAN branch wire when the resistance between terminals 18 (CA4H) and 17 (CA4L) of the central gateway ECU (network gateway ECU) is below 54 Ω. Symptom Trouble Area
*1: w/ Headup Display
*2: w/ ASC System *3: for T
© 2016-2026 Copyright www.lexunx.com
