Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
PROCEDURE
1. INSTALL COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
(a) Connect the aspirator hose.
(b) Connect the connector.
(c) Attach the 2 claws to install the cooler thermistor (room temperature sensor).
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here .gif)
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
5. INSTALL INSTRUMENT SIDE PANEL LH
Click here
6. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH
Click here
7. INSTALL UPPER REAR CONSOLE PANEL
Click here
8. INSTALL CONSOLE ARMREST ASSEMBLY
Click here
9. INSTALL COWL SIDE TRIM BOARD LH
Click here
10. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
Click here
READ NEXT:
Solar Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 AUTOMATIC LIGHT CONTROL SENSOR (SOLAR SENSOR) *2 NO. 1 SPEAKER OPENING COVER ASSEMBLY RemovalREMOVAL PROCEDURE 1. REMOVE NO. 1 SPEAKER OPENING COVER
SEE MORE:
Lost Communication with Cruise Control Module Missing Message (U010487)
DESCRIPTION The millimeter wave radar sensor assembly communicates with the forward recognition camera via CAN communication. If a communication error is detected between the forward recognition camera and millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores this D
Components
COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP SUB-ASSEMBLY *2 AIR CLEANER CASE SUB-ASSEMBLY *3 AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY *4 HEATER ACCESSORY ASSEMBLY *5 HEATER WATER INLET HOSE A *6 HEATER WATER OUTLET HOSE A *7 FUEL VAPOR FEED HOSE *8 NO. 2 FUEL VA
