Lexus NX: Room Temperature Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CONSOLE ARMREST ASSEMBLY *2 COOLER THERMISTOR (ROOM TEMPERATURE SENSOR) *3 COWL SIDE TRIM BOARD LH *4 DOOR SCUFF PLATE ASSEMBLY LH *5 INSTRUMENT SI
Removal
REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE CONSOLE ARMREST ASSEMBLY Click here 4. REMOVE UPPER REAR CONSOL
Inspection
INSPECTION PROCEDURE 1. INSPECT COOLER THERMISTOR (ROOM TEMPERATURE SENSOR) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Con
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / AFS / Trouble Codes. Body Electrical > AFS > Trouble Codes (e) Check for DTCs. CLEAR DTC (a) Connect the Techstrea
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the cylinder head sub-assembly. Click here PROCEDURE 1. INSTALL CYLINDER HEAD GASKET (a) Clean the cylinder block and cylinder head sub-assembly with solvent. (b) Apply a seal packing to a new cylinder he
© 2016-2026 Copyright www.lexunx.com
