Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR HEADER SPEAKER ASSEMBLY
NOTICE:
Do not touch the cone part of the speaker.
| (a) Temporarily install the speaker by attaching the clip of the speaker to the vehicles body. |
|
.png)
(b) Install the rear header speaker assembly with the bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(c) Connect the connector.
2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH
Click here .gif)
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Click here
4. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
Click here
6. INSTALL ROPE HOOK ASSEMBLY
Click here
7. INSTALL UPPER DECK TRIM SIDE BOARD LH
Click here
8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
Click here
9. INSTALL REAR DOOR SCUFF PLATE LH
Click here
10. INSTALL REAR FLOOR FINISH PLATE
Click here
11. INSTALL NO. 2 TOOL BOX SUB-ASSEMBLY
Click here
12. INSTALL NO. 1 TOOL BOX SUB-ASSEMBLY
Click here
13. INSTALL DECK FLOOR BOX RH
Click here
14. INSTALL DECK FLOOR BOX LH
Click here
15. INSTALL SPARE TIRE
Click here
16. INSTALL REAR DECK FLOOR BOX
Click here
17. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
18. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY
Click here
19. INSTALL DECK BOARD ASSEMBLY
Click here
20. INSTALL TONNEAU COVER ASSEMBLY
Click here
21. INSTALL REAR SEAT ASSEMBLY (for Power Seat)
Click here
22. INSTALL REAR SEAT ASSEMBLY (for Manual Seat)
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Type A *B for Type B *1 NO. 1 ANTENNA CORD SUB-ASSEMBLY *2 UPPER INSTRUMENT PANEL SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before serving. Click here NOTICE: After turning the power switch off, there may be a waiting time before disconnecting
SEE MORE:
Master Cylinder Pressure Sensor (C1246,C1281,C1364)
DESCRIPTION The regulator pressure sensor and wheel cylinder pressure sensor are built into the brake actuator. They measure their respective pressures and send signals to the skid control ECU (brake booster with master cylinder assembly). DTC C1281 will be cleared when the regulator pressure sensor
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of
