Lexus NX: Installation
Lexus NX Service Manual / Vehicle Interior / Seat / Power Seat Switch (for Front Seat) / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT POWER SEAT SWITCH LH
(a) Install the front power seat switch LH with the 3 screws.
2. INSTALL FRONT SEAT CUSHION SHIELD LH
Click here .gif)
3. INSTALL POWER SEAT SWITCH KNOB LH
Click here
4. INSTALL POWER SEAT SWITCH KNOB LH
Click here
5. INSTALL FRONT LOWER SEAT CUSHION SHIELD
Click here
6. INSTALL FRONT SEAT ASSEMBLY LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Front Side - - *1 CONSOLE ARMREST ASSEMBLY *2 COWL SIDE TRIM BOARD LH *3 DOOR SCUFF PLATE ASSEMBLY LH *4 INSTRUMENT SIDE PANEL LH *5
Removal
REMOVAL PROCEDURE 1. REMOVE CONSOLE ARMREST ASSEMBLY (for Front Side) Click here 2. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Front Side) Click here 3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER RELAY ASSEMBLY (w/ Rain Sensor) (a) Disconnect the I56 windshield wiper relay assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconn
Short in Selectable Force Limiter Squib RH Circuit (B1940-B1943)
DESCRIPTION The selectable force limiter circuit consists of the airbag ECU assembly and front seat outer belt assembly RH. This circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the selectable force limiter circuit. DT
© 2016-2026 Copyright www.lexunx.com
