Lexus NX: Power Seat Switch (for Rear Seat)
READ NEXT:
COMPONENTS ILLUSTRATION *A for Front Side - - *1 CONSOLE ARMREST ASSEMBLY *2 COWL SIDE TRIM BOARD LH *3 DOOR SCUFF PLATE ASSEMBLY LH *4 INSTRUMENT SIDE PANEL LH *5
REMOVAL PROCEDURE 1. REMOVE CONSOLE ARMREST ASSEMBLY (for Front Side) Click here 2. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Front Side) Click here 3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH
INSPECTION PROCEDURE 1. INSPECT NO. 1 FOLD SEAT SWITCH ASSEMBLY (for Front Side) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection
SEE MORE:
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the door side airbag sensors. PROCEDURE 1. INSPECT DOOR SIDE AIRBAG SENSOR (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Click here 2. INSPE
INSTALLATION PROCEDURE 1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER (a) Connect the connector to the tire pressure warning ECU and receiver. (b) Attach the 2 guides to temporarily install the tire pressure warning ECU and receiver. (c) Install the bolt. Torque: for bolt A : 8.3 N·m {85 kg