Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. INSTALL BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER)
HINT:
-
When installing the seat cover, refer to the precautions in order to prevent wrinkles from forming.
Click here
.gif)
-
Align the seam allowance in a single direction as shown in the illustration.
.png)
(a) Using hog ring pliers, install the bench type rear seat cushion cover (rear seat cushion heater assembly) to the bench type rear seat cushion pad with 28 new hog rings in the order indicated in the illustration.
.png)
| *1 | Hog Ring Pliers | - | - |
NOTICE:
- Be careful not to damage the bench type rear seat cushion cover.
- Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seat cushion cover.
| (b) Using hog ring pliers, install the bench type rear seat cushion cover (rear seat cushion heater assembly) with 39 new hog rings. |
|
.png)
| (c) Using hog ring pliers, install 6 new hog rings. |
|
.png)
2. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Click here
3. INSPECT SEAT HEATER SYSTEM (for Rear Seat)
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR SEAT CUSHION ASSEMBLY - - ILLUSTRATION *1 BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER) *2 BENCH TYPE REAR SEAT CUSHION PAD *
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE REAR SEAT CUSHION ASSEMBLY Click here 2. REMOVE BENCH TYPE REAR S
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU (a) Attach the claw and install the multiplex tilt and telescopic ECU to the bracket. (b) Install the bolt and multiplex tilt and telescopic ECU to the electric power steering column sub-assembly. (c) Connect the connector and harne
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL BACK DOOR LOWER DAMPER STAY BRACKET LH (a) Perform this procedure when replacing only the back door lower damper stay bracket LH.
