Lexus NX manuals

Lexus NX: Removal

Lexus NX Service Manual / Vehicle Interior / Seat / Rear Seat Cushion Heater(for Power Seat) / Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE

1. REMOVE REAR SEAT CUSHION ASSEMBLY

Click here

2. REMOVE BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER)

(a) Remove the 6 hog rings.

(b) Remove the 39 hog rings.

(c) Remove the 28 hog rings to remove the bench type rear seat cushion cover (rear seat cushion heater assembly).

READ NEXT:

 Inspection

INSPECTION PROCEDURE 1. INSPECT BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER ASSEMBLY RH) (a) Check the bench type rear seat cushion cover (rear seat cushion heater assembly RH). NO

 Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. INSTALL BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER)

 Rear Seatback Heater(for Manual Seat)

SEE MORE:

 Engine Failed to Start (P0A0F-204,P0A0F-205,P0A0F-206,P0A0F-524,P0A0F-525)

DESCRIPTION If an engine malfunction occurs, an engine malfunction signal is sent from the ECM to the hybrid vehicle control ECU. When the hybrid vehicle control ECU receives this signal, it stores a DTC and performs fail-safe control. DTC No. Detection Item DTC Detection Condition Trouble

 Steering Angle Sensor Initialization Incomplete (C1439,C1445)

DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) acquires the steering sensor zero point every time the power switch is turned on (IG) and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores previous zero points. DTCs C1439

© 2016-2026 Copyright www.lexunx.com