Lexus NX: Rear Seat Cushion Heater(for Power Seat)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR SEAT CUSHION ASSEMBLY - - ILLUSTRATION *1 BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER) *2 BENCH TYPE REAR SEAT CUSHION PAD *
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE REAR SEAT CUSHION ASSEMBLY Click here 2. REMOVE BENCH TYPE REAR S
Inspection
INSPECTION PROCEDURE 1. INSPECT BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER ASSEMBLY RH) (a) Check the bench type rear seat cushion cover (rear seat cushion heater assembly RH). NO
SEE MORE:
Accelerator Pedal Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 ACCELERATOR PEDAL SENSOR ASSEMBLY *2 ACCELERATOR PEDAL SENSOR CONNECTOR N*m (kgf*cm, ft.*lbf): Specified torque - - On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY (a) Connect the Techstr
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 5 MOULDING TAPE (a) Clean the No. 5 moulding tape installation surface with a non-residue solvent. (b) Apply primer to the No. 5 mo
© 2016-2026 Copyright www.lexunx.com
