Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY (for LH Side)
(a) for Manual Seat:
| (1) Attach the hook. |
|
.png)
| (2) Attach the clamp and install the seat heater control sub-assembly. |
|
.png)
(3) Connect the connector.
(b) for Power Seat:
| (1) Attach the hook. |
|
.png)
| (2) Attach the clamp and install the seat heater control sub-assembly. |
|
.png)
(3) Connect the connector.
2. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY LH (for LH Side)
Click here .gif)
3. INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY (for RH Side)
(a) for Manual Seat:
| (1) Attach the hook. |
|
.png)
| (2) Attach the clamp and install the seat heater control sub-assembly. |
|
.png)
(3) Connect the connector.
(b) for Power Seat:
| (1) Attach the hook. |
|
.png)
| (2) Attach the clamp and install the seat heater control sub-assembly. |
|
.png)
(3) Connect the connector.
4. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY RH (for RH Side)
Click here
5. INSTALL REAR SEATBACK COVER
Click here
6. INSTALL REAR SEATBACK ASSEMBLY RH
(a) for Manual Seat:
Click here
(b) for Power Seat:
Click here
7. INSTALL REAR SEATBACK ASSEMBLY LH
(a) for Manual Seat:
Click here
(b) for Power Seat:
Click here
READ NEXT:
Seat Heater Switch(for Rear Seat)
ComponentsCOMPONENTS ILLUSTRATION *1 CONSOLE BOX REGISTER ASSEMBLY *2 REAR CONSOLE END PANEL SUB-ASSEMBLY *3 REFRESHING SEAT SWITCH *4 DUCT RemovalREMOVAL PROCEDURE 1. REMOVE
Precaution
PRECAUTION FOR OPERATION OF ELECTRICAL ITEMS RESTRICTED NOTICE:
If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption / Partial Limit On AC/H
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 FRONT AXLE HUB BOLT LH *2 FRONT DISC *3 FRONT DISC BRAKE CALIPER ASSEMBLY LH - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part
Terminals Of Ecu
TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly. Click here *1 Main Body ECU (Multiplex Network Body ECU) - - (b) Con
