Lexus NX: Seat Heater System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Front Right Seat Heat Sensor Circuit (B14C0)
- Front Left Seat Heat Sensor Circuit (B14C1)
- Rear Right Seat Heat Sensor Circuit (B14C2)
- Rear Left Seat Heat Sensor Circuit (B14C3)
- Seat Heater Switch Circuit
- Seat Heater for Front Right Seat does not Operate
- Seat Heater for Front Left Seat does not Operate
- Seat Heater for Rear Right Seat does not Operate
- Seat Heater for Rear Left Seat does not Operate
READ NEXT:
Precaution
PRECAUTION FOR OPERATION OF ELECTRICAL ITEMS RESTRICTED NOTICE:
If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption / Partial Limit On AC/H
Parts Location
PARTS LOCATION ILLUSTRATION *A w/ Rear Seat Heater - - *1 AIR CONDITIONING CONTROL ASSEMBLY *2 SEAT HEATER SWITCH (for Driver Side) *3 SEAT HEATER SWITCH (for Front Passenger
System Diagram
SYSTEM DIAGRAM for Front: for Rear (w/ Rear Seat Heater):
SEE MORE:
Fuel Level Sensor "A" Circuit Range / Performance (P0461)
DESCRIPTION The fuel sender gauge is located inside the fuel tank and measures the amount of fuel. The fuel sender gauge converts the fuel level in the fuel tank into a output value, and outputs this value. The ECM determines when it is necessary to refuel the vehicle based on changes in the output
Installation
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (a) Tie the string that was passed through the engine compartment room to the end of the hood lock control cable assembly as shown in the illustration. HINT: Use a length of string long enough to pass through the engine compartmen
© 2016-2026 Copyright www.lexunx.com
