Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (SEAT BELT WARNING LIGHT)
(a) Connect the 2 connectors.
| (b) Attach the 6 clips to install the air conditioning control assembly (seat belt warning light). NOTICE: Do not touch the switch, display or clock parts. |
|
.png)
2. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here .gif)
3. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
4. INSTALL INSTRUMENT SIDE PANEL RH
Click here
5. INSTALL NO. 1 SWITCH HOLE BASE
Click here
6. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
8. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
9. INSTALL INSTRUMENT SIDE PANEL LH
Click here
10. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
Click here
11. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH
Click here
12. INSTALL UPPER REAR CONSOLE PANEL
Click here
13. INSTALL REAR CONSOLE ARMREST ASSEMBLY
Click here
14. INSTALL COWL SIDE TRIM BOARD LH
Click here
15. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
Click here
16. INSTALL MULTI-DISPLAY ASSEMBLY
Click here
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 AIRBAG ECU ASSEMBLY *2 PARKING BRAKE ECU ASSEMBLY *3 AIR CONDITIONING CONTROL ASSEMBLY *4 HYBRID VEHICLE CONTROL ECU *5 BRAKE BOOSTER WITH MAST
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Fuel Level Sensor "A" Circuit Range / Performance (P0461)
DESCRIPTION The fuel sender gauge is located inside the fuel tank and measures the amount of fuel. The fuel sender gauge converts the fuel level in the fuel tank into a output value, and outputs this value. The ECM determines when it is necessary to refuel the vehicle based on changes in the output
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 2 FORWARD RECOGNITION COVER Click here 2. REMOVE NO. 1 FORWARD RECOGNITION COVER Click here 3. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (a) Disconnect the connector. *a Connector *b Screw (b) Detach the clamp. (c) Using a T20 "TORX
