Lexus NX: Seat Belt Warning Light (for Rear Side)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR CONDITIONING CONTROL ASSEMBLY (SEAT BELT WARNING LIGHT) *2 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *3 COWL SIDE TRIM BOARD LH *4 DOOR SCUFF P
Removal
REMOVAL PROCEDURE 1. REMOVE MULTI-DISPLAY ASSEMBLY Click here 2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. REMOVE REAR CONSOLE ARMREST ASS
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONING CONTROL ASSEMBLY (SEAT BELT WARNING LIGHT) (for Rear Side) (a) Check the seat belt warning light illumination. OK: Measurement Condition Speci
SEE MORE:
Generator Control Module (P0A1A-151,P0A1C-709)
DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if the system is malfunctioning. If any of the following DTCs are output, replace the inverter with converter assembly. DTC No. Detection Item DTC Detection Co
Fuel Sender Open Detected (B1500)
DESCRIPTION This DTC is stored when the combination meter detects a fuel sender gauge malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area B1500 Fuel Sender Open Detected Both conditions are met:
IG voltage is 10.5 V or higher.
Average input signal of fuel s
© 2016-2026 Copyright www.lexunx.com
