Lexus NX: Intake System
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INTAKE SYSTEM
HINT:
Perform "Inspection After Repair" after repairing air leaks in the intake system.
Click here .gif)
(a) Check that there are no vacuum leaks at the points shown in the illustration.
READ NEXT:
Engine Oil Cooler
ComponentsCOMPONENTS ILLUSTRATION *1 OIL COOLER ASSEMBLY *2 GASKET *3 SEAL WASHER *4 UNION BOLT N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part Remova
Lubrication System
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL (a) Put the engine in inspection mode (maintenance mode). Click here (b) Warm up and stop the engine 5 minutes later
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. REMOVE REAR SUSPENSION ARM COVER LH Click here 3. DISCONNECT REAR SPEED SENSOR LH (a) w/ AVS: Click here (b)
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE SHIFT LEVER CAP (a) Using a screwdriver with its tip wrapped with protective tape, detach the 2 claws and remove the shift lever cap from the shift position indicator. *a Protective Tape 2. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (a) Deta
© 2016-2026 Copyright www.lexunx.com
